baltur 56760010, Instruction Manual For Installation, Use And Maintenance

Page: 78 / 96

MAINTENANCE
Analyse combustion gases and check that the emission values are
correct at least once a year, in compliance with current law.
• Clean air dampers, the air pressure switch with pressure port and
the relevant pipe, if any.
• Check the electrode condition. Replace them, if necessary.
• Clean the photocell. Replace it, if necessary.
•
Have the burner and the chimney cleaned by specialised person -
nel (stove repairer); a clean burner is more efficient, lasts longer
and is quieter.
• Check that the fuel filter is clean. Replace it, if necessary.
• Check that all components of the combustion head are in good
condition, have not been deformed and are free from impurities
or deposits deriving from the installation environment and/or from
combustion.
• Analyse combustion gases and check emissions values.
If the combustion head needs to be cleaned, remove the components
following the procedure indicated below:
• Remove the UV photocell.
• Disconnect the connectors of gas and diesel solenoid valves, the
gas servomotor and of the pressure regulator.
• unscrew the anchoring screws (12), and open the ventilating
body;
• pull out the ignition and ionisation cables from their electrode
terminals (13);
• Unscrew the caps (22), on one of which the pressure gauge indi-
cating the pressure in the return circuit is installed, to enable the
draining of the residual diesel still present in the atomization unit.
Disconnect the unit connection pipes, unscrewing the nuts (19).
• Unscrew the screw (8) from the buffer (17).
• Pull out the entire mixer unit in the direction shown by the arrow.
When you have finished maintenance work, proceed to reassem -
ble the combustion head, following the same procedure in rever -
se, after checking the correct position of the ignition electrodes.
0002951050N1
1
12
13
8
17
22
19
0002951050N12
30 / 46
0006160357_202305
ENGLISH