41
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
ACK NAK
Timeout Value
This option specifies the amount of time the reader waits for an ACK character from the host fol-
lowing label transmission. The selectable timeout range is 200 milliseconds to 15,000ms (15 sec-
onds) in 200ms increments. A selection of 0 disables the timeout.
for more information on setting this feature.
$CR2AT
Select ACK NAK Timeout Value Setting
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix D
appendix to enter numbers as you would
select digits/characters from a keypad.
rep-
resenting your desired character(s). End by
reading the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
~
CANCEL
DEFAULT
01 ACK NAK Timeout value is 200ms
