194
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
PDF417 Set Length 2
This feature specifies one of the barcode lengths for
PDF417 Length Control on page 192
Length 2 is the maximum label length if in Variable Length Mode, or the second fixed length if in
Fixed Length Mode. Length includes the barcode’s check, data, and full-ASCII shift characters.
The length does not include start/stop characters. Characters can be set from 01 to 2,710 char-
acters (pad with zeroes) in increments of 01. Any value greater than 2,710 will be considered to
be 2,710.
See
for detailed instructions on setting this feature.
$CP4L2
Select PDF417 Length 2 Setting
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix 18, Use the barcodes in this
appendix to enter numbers as you would
select digits/characters from a keypad.
rep-
resenting your desired character(s). End by
reading the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
~
CANCEL
DEFAULT
Length 2 is 2,710 Characters
