BALLHOG Icon Series, Installation And Owner'S Instructions

Page: 10 / 16

Step 3
Step 4
Flat
Washer
Flat
Washer
Flat
Washer
Backboard
Bolt
Backboard
Bolt
Lock
Washer
Nut
Rim Attachment
NOTE: Use all steps of the following instructions to install a reflex
rim. To install a static rim, follow all steps except Steps 2 and 6.
TIME OUT TIP: Your warranty card is located
behind protective sheeting. You MUST complete
and fill out this card to activate your warranty.
Step 1:
Unpack rim. Remove any remaining cardboard edge
protectors and protective sheeting from backboard.
IMPORTANT
• Four bushings are factory installed on the backboard. If
loose, make sure to have them seated properly when tighten-
ing rim bolts. If missing, contact Ball Hog .
DO NOT install rim without bushings. If the bushings are
not in place, glass backboards can shatter and acrylic
backboards can crack!
• Correct sequence of hardware installation MUST be followed
during assembly.
Step 2: If not already removed, remove cover plate
screws and cover plate from rim assembly.
Step 3:
Starting with the top two mounting holes,
loosely attach rim to backboard following the
hardware sequence
as shown in the illustration below. Snug
tighten hardware - a
9
/
16
” open-end wrench may be necessary.
Step 4: Repeat hardware sequence outlined in Step 3
for lower rim mounting holes.
Step 5:
Level rim side to side and then fully tighten
hardware.
Step 6:
Position cover plate and attach with cover
plate screws.
Step 7:
Attach net to rim.
3
/
8
x 2”
Backboard Bolt (4) 3
/
8
” Flat Washer (8)
3
/
8
” Lock Washer (4)
3
/
8
” Nut (4)
Cover Plate
Screw (4)
Step 6
Cover Plate
Screw
Cover Plate
Screw
Cover
Plate
HARDWARE:
TOOLS:
Level,
9
/
16
” Wrench,
9
/
16
” Socket, Phillips Screwdriver
10
TIME OUT TIP: Level rim side to
side before tightening backboard bolts.
Factory Installed Bushing
(Backboard damage can result if not installed)