3
1 INTRODUCTION
Thank you for purchasing the Adjustable Frequency Drive, ID5601-EO. Baldor, Inc. is committed
to providing total customer satisfaction by producing quality products that are easy to install and
operate. The ID5601-EO is manufactured with surface mount components incorporating
advanced circuitry and technology. The ID5601-EO is an Adjustable Frequency Drive which is
capable of variable speed control. In addition, it is housed in a NEMA-1 / IP-40 enclosure. It is
designed to operate 208 – 230 Volt 50 & 60 Hz 3-phase AC induction motors from 1/8 HP thru 1
HP. The sine wave coded Pulse Width Modulated (PWM) output operates at a carrier frequency
of 16 kHz which provides high motor efficiency and low noise. Adjustable Linear Acceleration
and Deceleration make the drive suitable for soft-start applications. The Motor Horsepower
Selection Jumper allows the drive to be used on a wide range of motor horsepower (1/8, 1/4,
1/2, 3/4, 1 HP) without recalibration or programming.
Its user-friendly design makes the ID5601-EO easy to install and operate. Setting the drive to
specific applications is accomplished with selectable jumpers and trimpots, which eliminates the
computer-like programming required on other drives. However, for most applications no
adjustments are necessary.
Main features include adjustable RMS Current Limit and I
2
t Motor Overload Protection.
1
In
addition, Adjustable Flux Vector Compensation with Static Auto-Tune and Boost provides high
torque and excellent load regulation over a wide speed range. Power Start™ delivers over 200%
motor torque to ensure startup of high frictional loads. Electronic Inrush Current Limit (EICL™)
eliminates harmful AC line inrush current. A Run/Fault Relay is provided, which can be used to
turn on or off equipment or to signal a warning if the drive is put into the Stop Mode or a fault has
occurred.
Standard front panel features include an On/Off AC Line Switch, a pilot light for power on, and a
Main Speed Potentiometer. Other features include PC board mounted diagnostic LEDs (Power
On (ON), Drive Status (ST) and Overload (OL)), Barrier Terminal Blocks to facilitate wiring (AC
line, motor, ground (earth), and Run/Fault Relay Output Contacts), adjustable trimpots (MIN,
MAX, ACCEL, DECEL, COMP, CL), customer selectable jumpers (AC Line Input Voltage
Selection, Motor Horsepower, Automatic or Manual Start and Reset
2
, Motor Frequency,
Frequency Multiplier, and a Run/Fault Output Relay). Refer to Tables 1 – 8, on pages 4, 5, and
6.
Optional accessories include: Forward-Stop-Reverse Switch.
Notes:
1.
UL approved as an electronic overload protector for motors.
2.
The optional Forward-
Stop-Reverse Switch is required for Manual Start
.
This product complies with all CE directives pertinent at the time of manufacture.
Contact your local Baldor District Office for Declaration of Conformity. Installation of a CE
approved RFI filter is required. Additional shielded cable and/or AC line cables may be
required along with a signal isolator.
