Owner’s Manual Baldertech Balder
| Baldertech 29
5.3. Stand up function
Balder Finesse and Balder Junior are available with a stand up function. Read this section if it is
applicable to your wheelchair.
DANGER
When in standing position, the wheelchair must only be used indoors and
on a flat surface.
NOTE
The starting position is the position to which the chair will return when you switch back from
standing position.
NOTE
It is important to adjust the footrest into the correct position before switching to standing posi
-
tion, as this function will not be available once the chair is in this position.
NOTE
If you use the stand up function from horizontal position, the abduction pad must not be put on
until the legs are in the horizontal position.
NOTE
When the support legs are activated, the stand up function will stop for a moment to wait for
the support legs to move into the correct position. If the support legs cannot be activated au
-
tomatically, a green light will flash on the stand up function panel. In this instance, return to the
starting position, move the chair slightly and try again.
NOTE
In standing position, only the back will be adjustable, to a restricted extent. The footrest, raise
and tilt functions are disabled for safety reasons while the chair is in the upright position.
NOTE
The chair can be programmed so that the back cannot be operated or adjusted while the chair
is in standing position.
NOTE
The fixings for the stand up function, knee brace cushion and chest belt, do not replace a safety
belt in a car. Ensure correct fixing for use of the stand up function.
