Baldan DCF-CO, Instruction Manual

Page: 51 / 122

Instruction Manual
DCF-CO 51
ƒ
Adjustments
Before starting work, calibrate the RPM of the hydraulic engine (8) as follows:
• Calibration RPM (Hydraulic Engine) - Part II
01 - First start the tractor.
02 - Then, approach the tachometer (1) to
the hole of the guard plate (5).
03 - Then turn the tachometer (1) in the
optical function and measure the RPM.
If the result is not 540 RPM, adjust the
RPM on the tractor and redo the
measurement to the recommended
540 RPM for the work.
03 - Then cut the sticker (6) at the size of 1 cm and glue it to the shaft (7). Finish by reinstalling the
protection plate (5).
7
6
Only perform the calibration after fixing the protection plate (5). Ignoring
this warning may cause severe accidents or death.
ATTENTION
It is necessary to glue the sticker (6) on the
shaft (7) so that the tachometer (1) can
perform the calibration.
IMPORTANT
8
5
1