Baldan DCF-CO, Instruction Manual

Page: 105 / 122

Instruction Manual
DCF-CO 105
ƒ
Maintenance
- Detergents with acid active ingredients (lower than 7 pH), act as zinc stripper/
remover (parts protection against oxidation).
- Detergents with a basic active ingredient (pH less than 7), can damage/stain the
paint on the distributor.
04 - Stains and dirt not removed with the products should be removed with the aid of a sponge.
05 - Rinse the machine with clean water to remove any chemical residues..
06 - Do not use:
07 - Allow the machine to dry in the shade so that it does not accumulate water in its components.
Very fast drying can cause stains on your paint.
08 - After drying, lubrificate all chains and greases according to the recommendations in the
operator’s manual.
09 -
Spray the whole machine, especially zinc parts, with protective oil, following the
manufacturer’s application instructions. The protective also prevents dirt from
adhering to the machine, facilitating subsequent washings.
10 - Observe curing (absorption) time and application intervals as recommended by the
manufacturer.
Do not use any other type oil to protect the distributor (used hydraulic oil,
burnt oil, diesel, castor oil, kerosene, etc.).
ATENTION
We recommend the following protective oils:
- Bardahl: Agro protective 200 or 300
- ITWChemical: Zoxol DW - Series 4000
IMPORTANT
Ignoring the conservation measures mentioned above may result in loss of warranty
for painted or zinc-coated components which may suffer oxidation (rust).
NOTE