background image

1 of 2

Model

40-100

Q U I C K   S TA R T

  G U I D E

1

A2

A3

A7

A5

A6

A4

IMPORTANT

r

r

Unpack box and make sure you have all items shown here.

(Hex nuts to mount to controller faceplate should be with faceplate)

Drill 5/8-inch pass-through hole in  

surface in center of desired reader 

mounting location.

Feed Reader Base wiring through 

pass-through hole, and wire reader to 

Wiegand controller 

(not included).

Snap Reader Cover onto Base, lining up 

LED lens on Base with slot in Cover. 

Parts will snap together securely.

Hold Reader Base against mounting 

surface, and use nail to tap two marks.

Reader Cover

Self-Tapping Screw

( 2x )

Mount Reader Base to surface using 

Self-Tapping Screws. Use drywall 

anchors 

(not included)

 if desired

.

Power up Wiegand controller, and 

make sure Reader is working correctly 

by scanning a valid card 

(not included).

Faceplate Screw

( 2x )

Reader Base

Refer to Wiegand controller instructions for wiring 

details. If controller only has one LED terminal, connect 

gray wire (green LED) for standard operation.

Nail not included.

If mounting the proximity card reader to a 

surface like a wall or door frame, proceed to 

Step A2

 on this page.

If mounting the proximity card reader to a 

controller faceplate, remove the cover plate or 

current card reader, keep the hex nuts handy, 

and proceed to 

Step B2

 on the next page.

Pre-drill

appropriately

sized holes

if using anchors

 or if mounting

to metal.

Reviews: