Page 5
3. Run a flexible non-metallic conduit from the power source to the spa, through the
hole in the left or right front corner and into the electrical control box.
4. After pulling all lead wires through the non-metallic conduit, strip 10mm of
insulation off one end of each lead wires.
5. Connect the lead wires to the proper terminals as indicated by the wiring diagram
on the back of the control box cover. Make sure the wires are properly tightened.
6. A grounding lug has been provided on the exterior of the control box to allow
connection of a ground wire to a local grounding point to be established in
