Page 4
not use aluminous wire. Do not use aluminous wire.
(3) The power supply must have a suitable residual current device (RCD). This could
be used as the shut-off switch, which must be installed in plain view of the spa. This
electrical service must be readily accessible to the spa owner, but must not be within 5
feet (1.5m) of the spa.
(4) Use only non-metallic conduit and fittings while installing power to your spa.
(5) After your spa has been positioned, route lines through the knockout on the left or
right front corner of your spa.
(6) Connect the electrical power to your spa.
ELECTRICAL CONNECTIONS
To hook up your spa, please follow the instructions below:
1. Remove the screws and cabinet panel on the side of the spa under the topside
control panel, and then set the cabinet panel aside.
2. After removing the cabinet panel, locate the electrical control box. Loosen the
screws on the front of the control box. Remove the screws and the control box
cover.
