Figure 6
CORRECT USE OF THE MIXER
It is the responsibility of the users to use the
mixer
correctly
within
the
recommended
limitations. Always follow the instructions on this
handbook when changing gear. If the motor labors,
stop the machine and reduce the size of the mix
immediately. Damage resulting from improper
use is not covered by the Max Mec warranty.
For operator safety, please turn the speed
selector to the OFF position before install mixing
tools, fixing or moving bowl cradle.
Furthermore, the machine is fitted with a bowl
guard which is electrically interlocker to ensure
that the mixer cannot operate unless the guard is
correctly positioned and the bowl is raised.
For additional safety the mixer has a no bolt
release feature which means that in the event of a
power failure, the machine will only restart after
the ON/OFF Speed Selector Button has been
regressed. This arrangement ensures that when
the supply is restored, the machine cannot restart
on its own.
- Careful handling of bagged products by
minimizing the height above the bowl base from
which they are poured.
- Careful slitting of bags in the lower part of the
bowl to allow dust free discharge of flour as far
as possible.
- Use of Temporary bowl covers to minimize
openings through which flour may escape.
THERMAL OVERLOAD
PROTECTION (Automatically Reset)
The thermal overload protection (circuit
break) will shut off and stop the machine
automatically. If this occurs, please turn the
ON/OFF speed selector button to 0-OFF position
and reduce the size of the batch. After waiting 1-2
minutes machine shut off, turn the ON/OFF speed
selector or button to ON position. The thermal
overload protection is an automatic reset device.
The circuit breaker may be different base on
mixer’s voltage. *Figure 3 shows the position of
110V (3A) circuit breaker. Figure 4 shows the
position of 220V (2A) circuit breaker.
*110V(3A)circuit breaker must be manually
reseted.
Note:
Once the circuit breaker over loaded
and shut off the machine happens frequently,
please replace the circuit breaker.
FITTING THE BOWL
With the bowl
cradle lowered, place
the chosen mixing
tool in the bowl and
position the bowl on
the cradle. There are
three locational points
for the bowl:
(a) The locking pin at the rear of the bowl should
locate in the hole of the cradle.
(b) The two weld clips in the bowl handles must
engage on the locating pins located on the
cradle.
(c) Latching the bowl locking.
Please ensure that the bowl is seated
correctly on the cradle before securing the bowl
locking latches prior to use.
BOWL LIFT & BOWL GUARD
The bowl cradle and
bowl guard are
electrically interlocked
so that the machine will
only operate with the
bowl cradle in the raised
position. Please see
Figure 6.
In addition to this,
the bowl guard must be
placed into position by aligning its two pins into
the two small holes on the both side of the bowl.
Only once the bowl is raised and the bowl guard
locks, the machine can operate. Thus ensuring
total user safety at all times.
For start machine, raising right the bowl lift
handle in 180
∘
anti-clockwise direction to the top.
Once mixing is finished, turn off the machine and
lower down the bowl handle in clockwise
direction.
During the mixing process, additional
ingredients can be added by the chute located on
the right hand side of the bowl guard.
TOOL SELECTION
Figure 3
Figure 4
Figure 5
