Baker Hughes Panametrics PanaFlow Z3, User Manual

Page: 63 / 118

PanaFlow Z3 User’s Manual 51
Chapter 4. Error Codes and Troubleshooting
E23: Multi Channel
Accuracy Two or more
measurement
channels are in error Two or more measurement
channels are in error;
accuracy of the
measurement may be
compromised because the
meter is using a sister chord
substitution Check individual channel errors, refer
to this table for recommended
actions to correct channel errors
E27: Invalid
K-Table K-Table is invalid The entered K-table is
invalid. Check the K-table values and ensure
the Velocity or Reynolds Number in
the table is in ascending order.
E28: Software Fault Software malfunction This is a Software
malfunction. Try power
cycling the meter. If error
persists after power cycle,
contact BakerHughes
factory The condition is not self-recovering
and will not automatically correct
itself. Try power cycling the meter. If
error persists after power cycle,
contact BakerHughes factory
E29: Velocity
Warning The measured velocity
exceeds programmed
warning limits This error may be caused by
incorrect programming,
poor flow conditions and/or
excessive turbulence Make sure the actual flow rate is
within the programmed Warning
limits (Refer Programming Chapter).
Refer to
“Fluid and Pipe Problems” and
“Transducer Problems” sections to
correct any issues
E31: Not Calibrated The flow meter has not
been calibrated The flow meter has not been
calibrated and hence not
making measurements.
Please contact
BakerHughes factory The condition is not self-recovering
and will not automatically correct
itself. Contact BakerHughes factory to
get more information on the meter
setup
Table 17: Flow Error description and Recommended Actions
Error Code Problem Cause Recommended Action