Baker Hughes Masoneilan SVI II AP, Quick Start Manual

Page: 56 / 108

© 2018 Baker Hughes, a GE company, LLC. All rights reserved.
56 | = BHGE
Configuration with Pushbuttons
Prior to changing the SVI II AP configuration, check the existing configuration.
Viewing Configuration Data
To view SVI II AP configuration data:
1. Access the VIEW DATA menu from the MANUAL menu by pressing the + button.
2. In the VIEW DATA menu, press * to examine the configuration.
3. Press + to scroll through and observe the factory configuration.
4. Press + until MANPOS appears.
5. Select with * .
6. When the adjustment screen appears stroke the valve open by h down.
The rate of set point change is slow to begin, but increases speed while the + is
pressed.
7. Stroke the valve to several values.
8. Verify the action is as desired.
9. Press
+ to move to the SETUP menu.
10. In the SETUP menu press the * button to access the CONFIGuration menu.
11. In the CONFIG menu set the configuration parameters.
12. When in CONFIGure or CALIBrate , pressing * changes values.
13. Return to NORMAL mode. The valve moves to the value set by the current
calibrator.
14. Stroke the valve through its range to verify that the movement is as desired.
Configuration Menu
Because calibration depends on certain configuration options you must perform Configuration
before you perform Calibration when installing the SVI II AP for the first time.
If a change is made in the Air-to-Open / Air-to-Close configuration option or if you move the SVI
II AP to a different valve or make any change to the valve position linkage, you must run the find
STOPS calibration again.