Baker Hughes Druck 8000 Series, Instruction Manual

Page: 8 / 44

Copyright 2010 Baker Hughes Company.
vi | TERPS Instruction Manual–English
5.6 Measuring Pressure 12
5.7 Factory Defaults 12
6. Programming Guide 13
6.1 Command Summary 13
6.2 Communication Modes 14
6.2.1 Direct Mode 14
6.2.2 Addressed Mode 14
6.3 Command Syntax 14
6.3.1 Direct Mode Syntax 15
6.3.2 Addressed Mode Syntax 15
6.4 Measurement Commands 15
6.4.1 R - Get Reading 15
6.4.2 G - Get New Reading and Transmit 16
6.4.3 Z - Read Raw Data 16
6.5 Information Commands 16
6.5.1 I - Transducer Identity 16
6.6 General Set-up Commands 17
6.6.1 A - Auto-send Reading 17
6.6.2 N - Set Device (Transducer) Address 18
6.6.3 Q - Set Measurement Speed 19
6.6.4 U - Set Units 19
6.7 PIN Protected Set-up Commands 20
6.7.1 C - User Calibration 20
6.7.2 H - Change Slope 21
6.7.3 M - User Message 22
6.7.4 O - Communication Settings 23
6.7.5 P - Change PIN 24
6.7.6 S - Set Offset 25
6.8 Factory Commands - Query Only 25
6.8.1 E - Crystal Reference Frequency 25
6.8.2 L - Load Calibration Coefficients 26
6.8.3 T - Analogue/Digital Converter Set-up 26
6.8.4 V - Transducer Type and Settings 27
6.8.5 W - EEPROM Query 27
6.9 Error Messages 28
6.9.1 Incorrect User Command 28
6.9.2 Transducer Fault 28
Appendix A. Fault Finding 29
Appendix B. RPS EEPROM Format 31