17
2-1
2-1
2-2
2-2
2-3
2-3
1-1
1-1
Horizontal – Drain
Horizontal –
Anchoring
Point
Vertical –
Drain
Vertical –
Anchoring
Point
Vertical –
Air Intake
Pipe
11-- 33
INSTALLATION INSTRUCTIONS |
OWNER’S MANUAL
www.bainultra.com
Some products, specifications, and services mentioned in this manual are described in pending patent applications or are protected by patents.
2. INSTALLATION
BALNEO
®
- NAOS & SANOS
INSTALLATION
Bottom view
1. BATH SITE
1-1
Once the floor has been finished and
is perfectly level, place ThermoMas-
seur
®
in the exact chosen location.
Trace the outline of the bath with an
erasable marker.
1-2
Remove the ThermoMasseur and care-
fully place it upside down on a blanket
or corrugated cardboard (ex. the box in
which it was delivered).
1-3
On the floor, determine by referring to
measurements taken underneath the
bath, the exact location of the drain,
the air pipe, and the two anchoring
points at each end of the bath.
2-1
Install the drain and overflow set on
the bath and the first section of the
air intake pipe (1 1/2’’ ABS) under the
floor.
2-2
Apply a silicone joint to the base rim.
2-3
Put the ThermoMasseur in place and
put pipes through the floor, ensuring
bath is aligned with anchoring points.
For Geysair-equipped baths, also run
the water hose and electrical wiring
through the floor.
2-4
Wipe off excess silicone immediately.