INTRODUCTION
I-E96-221A
3 - 1
SECTION 3 - INSTALLATION
INTRODUCTION
This section explains how to install the IMCPM02 Communica-
tion Port Module. Do not proceed with operation until you read,
understand and do the steps in the order in which they appear.
Refer to the product instructions for NIMP01 and NIMP02 mod-
ules and NTMP01 unit for termination device wiring instruc-
tions.
NOTE: This module uses connections to the MMU backplane that
serve other functions in early Network 90 systems. To avoid poten-
tial module damage, your system must be checked for compatibility
prior to module installation. In INFI 90 systems, pins 3 and 4 of pin 1
are used for the redundant Controlway bus. Set J12 for your appli-
cation before installing the IMCPM02 module into the system.
SPECIAL HANDLING
NOTE: Always use Bailey's Field Static Kit (P/N 1948385A2 - con-
sists of wrist strap, ground cord assembly, alligator clip) when work-
ing with modules. The kit is designed to connect a technician and
the static dissipative work surface to the same ground point to pre-
vent damage to the modules by electrostatic discharge.
Use the static grounding wrist strap when installing and
removing modules. Static discharge may damage MOS devices
on modules in the cabinet. Use grounded equipment and static
safe practices when working with modules.
The IMCPM02 module uses electrostatic sensitive devices. Fol-
low Steps 1 through 8 when handling:
1.
Use Static Shielding Bags
. Keep the modules in the
static shielding bag until they are ready to be used in the sys-
tem. Save the bag for future use.
2.
Ground Bags Before Opening
. Before opening a bag con-
taining an assembly with CMOS devices, touch it to the equip-
ment housing or ground to equalize charges.
3.
Avoid Touching Circuitry.
Handle assemblies by the
edges; avoid touching the circuitry.
4.
Avoid Partial Connection of CMOS Device
. Verify that all
devices connected to the modules are properly grounded
before using them.
5.
Ground Test Equipment
.
