Bailey Infi 90 IMCPM02, Instructions Manual

Page: 47 / 55

INTRODUCTION
I-E96-221A B - 3
APPENDIX B - NIMP01 TERMINATION MODULE
CONFIGURATION
INTRODUCTION
The IMCPM02 module can use the NIMP01 termination module
for termination. Figure
B-1 shows the dipshunt configuration
required for connection to a modem. Figure B-2 shows the dip-
shunt configuration required to operate as an EWS port. Figure
B-3 shows the jumper assignments for handshake signals.
These jumpers are normally installed. Figure B-4 shows the
required jumper settings for J14 through J17. Figure B-5
shows the required jumper setting for J18. Figure B-6 shows
the NIMP01 connector assignments and jumper locations. Fig-
ure
B-7 shows the cable connection.
NOTE: Port 1 is the EWS port. Port 2 is the utility port and is
unavailable.
Figure B-1. NIMP01 Dipshunt Configuration for Modem (DCE)
Connection
Figure B-2. NIMP01 Dipshunt Configuration for EWS (DCE)
Connection
P5-3
P5-2
P5-8
+5 VDC
+5 VDC
RXD
TXD
CTS
RTS
RXD
TXD
CTS
RTS
P5-7
T00058A
1
2
3
4
8
7
6
5
P5-3
P5-2
P5-8
+5 VDC
+5 VDC
RXD
TXD
CTS
RTS
RXD
TXD
CTS
RTS
P5-7
T00059A
1
3
2
4
8
6
7
5