INTRODUCTION
I-E96-207A
3 - 1
SECTION 3 - INSTALLATION
INTRODUCTION
This section explains what you must do before you put the
Controller Module (IMCOM03/04) into operation. Do not pro-
ceed with operation until you read, understand and do the
steps in the order in which they appear.
NOTE: Refer to product instruction I-E93-911 for termination device
wiring instructions.
SPECIAL HANDLING
NOTE: Always use Bailey's Field Static Kit (P/N 1948385A2 - con-
sists of wrist strap, ground cord assembly, alligator clip) when work-
ing with modules. The kit is designed to connect a technician and
the static dissipative work surface to the same ground point to pre-
vent damage to the modules by electrostatic discharge.
The controller module (COM) uses electrostatic sensitive
devices. Follow steps one through four when handling it:
1. Keep the module in its special antistatic bag until you are
ready to install it in the system. Save the bag for future use.
2. Ground the antistatic bag before opening.
3. Verify that all devices connected to the module are properly
grounded before using them.
4. Avoid touching the circuitry when handling the module.
UNPACKING AND INSPECTION
1. Examine the hardware immediately to verify that it has not
been damaged in transit.
2. Notify the nearest Bailey Controls sales office of any such
damage.
CAUTION
This equipment contains MOS devices. Use the special han-
dling procedures listed below to avoid damage of MOS Devices
by static changes.
ATTENTION
Observez les procedures de manipulation prescrites pour
eviter les dommages causes par les changes statiques.
