Baileigh TS-1040E 30, Operator'S Manual

Page: 25 / 52

22
22
10 Install the blade guard and riving knife
A.
Reinstall the insert, slide the knurled knob out (see Fig) and rotate it forward so it
engages the upper bracket.
B.
Slide the blade guard spreader all the way down into the block, then rotate the knurled
knob so it disengages the bracket and the locking pin engages the hole in the center of the
spreader.
C.
Give the spreader an upward tug to verify that it is locked the blade guard. When properly
installed, it should look like Fig. on right, and should pivot freely so it touches the table surface in
the down position. It should also swing up high enough to accommodate the workpiece.
Knurled knob used Blade guard installed.
D.
Adjust the level adjust screws (as Fig) to make sure the table insert is flush with the table.
E. Place a straightedge against the blade and the spreader. When properly aligned, the
spreader/riving knife will be in the "alignment zone," shown in Fig, and will be parallel with the
blade.
Insert Alignment zone
CAUTION:
After changing a saw blade, always check that the Riving
knife or Blade Guard is correctly set!