17
17
ASSEMBLY AND SET UP
Two Person Lift. A lifting device will be needed, and an assistant is highly
recommended. Use an assistant or lifting devise (recommended) to support the weight of the
drill head during assembly.
1. Open the carton and inspect the contents.
2. Lift the base, column, and table assembly out of the
carton and position where the drill is intended to be
placed.
3. Use the mounting holes as a template and mark the
location on the bench for the anchor bolts.
4. Install the anchor bolts (customer supplied) and
secure the base, column, and table assembly to the
bench with the anchor bolts.
5. Using an appropriate lifting devise, carefully lift the
head assembly out of the carton and over the
column.
6. Insert the column into the pocket on the bottom of
the head assembly until the column is fully seated
into the head pocket.
7. Install the slip wedge pin and clamping bolt
assembly into the casting with the taper (A) toward
the column. (Taper shown up for visibility.)
8. Install the treaded wedge pin in from the opposite
side and lightly tighten the clamping bolt.
WARNING:
For your own safety, DO NOT connect the machine to the
power source until the machine is completely assembled and you read and
understand the entire instruction manual.
A
Summary of Contents for DP-3814B
Page 17: ...15 15 GETTING TO KNOW YOUR MACHINE K G M E O I D R S P Q B J A C H N F L...
Page 33: ...31 31 PARTS DIAGRAM...
Page 38: ...36 36 NOTES...
Page 39: ...37 37 NOTES...
