Baileigh DP-3814B, Operator'S Manual

Page: 27 / 40

25
25
Depth Stop
This drill press comes with a depth stop adjustment
for use when drilling.
1. Loosen the depth collar lock knob (A).
2. Secure the material you will be drilling onto the drill
press table.
3. With the desired bit installed, lower the spindle
until the tip of the bit just touches the material you
will be drilling. Hold the spindle in this position.
4. Turn the depth collar to the desired depth indicated
by the scale on the collar (B).
5. Secure the collar by tightening the lock knob (A).
6. Remove the material and test the depth stop by
measuring how far the spindle travels when the handles are rotated.
Drill Protection Guard
The machine is provided with a security drill guard.
Before pressing the starting push button, set the drill
guard in the working position, otherwise the machine
controls will not start.
Important: If the guard is opened when
operating the machine, the machine will stop. DO NOT
REMOVE THE GUARD UNDER ANY
CIRCUMSTANCES.
The drill guard can be adjusted for height and position.
1. Loosen the two thumb knobs (A) to increase or
decrease the height of the drill guard.
2. Slide the lower half of the guard up or down within
the slots to set the height.
3. Tighten the thumb knobs to hold the lower guard in
position.
4. The drill guard can slide up within the mounting
bracket with the stop block (B) stopping the
downward travel. (Drill guard shown fully lowered.)
B
A
A
B