Baileigh DP-3814B, Operator'S Manual

Page: 18 / 40

16
16
Item Description
A Base with work surface and T-slots.
B Worktable with T-slots.
C Chuck Guard with safety interlock.
D Chuck.
E Operator Controls
F Safety interlock switch for the Chuck Guard.
G Removable Drive Cover. Provides access to the sheave to change the spindle speed.
H Belt tension lock knobs. Two, one on each side.
I Drive Motor.
J
Head to Column Clamping Bolt. Allows head to pivot on the Column.
WARNING:
Before operating the Baileigh Drill Press make sure it is
firmly secured to a bench. If it tips over on you, it could cause severe injury or
death.
K Depth Stop Lock Knob.
L
Head Elevation (Lift/Lower) Collar. Use Adjusting Rod to assist with raising and
lowering the head. (Adjusting Rod not to scale)
M Quill Feed Handle.
N Column with Head Elevation Thread.
O Table Elevation Lock Handle.
P
Emergency Stop Button (Estop). In the event of incorrect operation or dangerous
conditions, the machine can be stopped immediately by pressing the
E-STOP button.
Twist the emergency stop button clockwise (cw) to reset. Note: Resetting the E-Stop
will not start the machine.
Q
Spindle Speed Chart. Use the chart as a guide for setting the spindle rpm for a drilling
operation. Note: This chart is a guide. Specific results will vary. Consult the drill
manufacturer for more detailed drilling information.
R
Green Start Button. Verify that the spindle and chuck are clear, the bit is secure and
held firm. Press to the motor and thus spindle rotation.
S Red Stop Button. Press to stop the motor and spindle.