5
Figure 4-2
3. Using nine M8 x 20 Round-Head Square-Neck
Carriage Bolts (item #2) with M8 Flanged Nylock
Hex Nuts (item #4), attach End Panel (item #15)
and three Tank Supports (item #16) to the
Shelf/Side Panel assembly as shown in Figure 4-
3. Attach to the end of the Shelf/Side Panel
assembly where the Angled Shelves are at their
lowest point. For the top and middle Tanks
Supports, insert the Carriage Bolts through the
Tank Supports, End Panel, and Angle Shelves.
For the bottom Tank Support, only insert the
Carriage Bolt through the Tank Support and End
Panel.
Do not fully tighten nuts at this time.
NOTE: You can mount the tank supports as shown
for two smaller tanks or flip them over for one
single larger tank.
Figure 4-3
4. Using four M8 x 20 Round-Head Square-Neck
Carriage Bolts (item #2) with M8 Flanged Nylock
Hex Nuts (item #4), attach Handle Mounts (item #
25) to Side Panels, just beneath the top Angled
Shelf, as shown in Figure 4-4.
Fully tighten nuts.
Figure 4-4
5. Using two M8 x 20 Hex Flange Bolts (item #24)
attach the Handle (item #31) to the Handle Mounts
as shown in Figure 4-5.
Fully tighten these two
bolts at this time.
Summary of Contents for B-CART-W
Page 14: ...14 NOTES ...
Page 15: ...15 NOTES ...
