Baileigh B-CART-W, Assembly And Parts Manual

Page: 8 / 16

8
16. Using the lower Mig-Tig Holder Bracket, attach the
Tig Torch Holder (item #23) to the bracket using
one M10 x 20 Hex Flange Bolt (item #37) and M10
Flanged Nylock Hex Nut (item #36), as shown in
Figure 4-14. You can adjust the Tig Torch Holder
to an angle that best suits your need.
Fully-
tighten this nut.
Figure 4-14
17. Assemble Magnet (item #28) to Door Stop (item
#29) using a M4 x 12 Cross Recessed Head
Screw and M4 Hex Flange Nut (item #30) as
shown in Figure 4-15. Repeat this for the second
Magnet/Door Stop assembly.
18. Using four M4 x 12 Hex Fange Bolts (item #26)
and four M4 Hex Nuts (item #30), attach both
Magnet/Door Stop assemblies to the cart
assembly Side Panel as shown in Figure 4-15.
Figure 4-15
19. Using one M8 x 20 Hex Flange Bolt (item #24),
attach the Door Lock (item #32) and Door Knob
(item #33) to the Door (item #40), as shown in
Figure 4-16. Make sure the Door Lock is
positioned between the Door and the Door Knob.
NOTE: After the welding cart is assembled, you
can lock the storage area door using a padlock.
Figure 4-16
20. Using six M4 x 12 Cross Recessed Head Screws
(item #27) and M4 Hex Flange Nuts (item #30),
attach two Door Hinges (item #34) to the Door
(item #40), as shown in Figure 4-17.
Figure 4-17