7
Figure 4-9
11. Using Three M8 x 20 Round-Head Square-Neck
Carriage Bolts (item #2) with M8 Flanged Nylock
Hex Nuts (item #4), attach Side Shelf (item #10) to
cart assembly Side Panel as shown in Figure 4-
10.
Fully-tighten these nuts.
Figure 4-10
12. Place remaining Tig Filler Rack (item #11) into the
Side Shelf as shown in Figure 4-11. Make sure this
lower Tig Filler Rack is positioned directly below
the upper Tig Filler Rack. Attach to the Side Shelf
using two ST4.8 x 13 Screws (item #9) as shown
in Figure 4-10.
Fully-tighten these screws.
Figure 4-11
13. On the opposite side of the cart assembly, using
four M8 x 20 Round-Head Square-Neck Carriage
Bolts (item #2) with M8 Flanged Nylock Hex Nuts
(item #4), attach four Cable Hooks (item #19) as
shown in Figure 4-12.
Fully-tighten these nuts.
Figure 4-12
14. On the same side as the Cable Hooks, using two
M8 x 20 Round-Head Square-Neck Carriage Bolts
(item #2) with M8 Flanged Nylock Hex Nuts (item
#4), attach two Mig-Tig Holder Brackets (item #22)
to the Side Panel flange, as shown in Figure 4-13.
Space these two brackets to meet your needs.
Fully-tighten these nuts.
Figure 4-13
15. Using the upper Mig-Tig Holder Bracket, attach
the Mig Gun Holder Tube (item #20) to the bracket
using one M10 x 55 Hex Flange Bolt (item #21)
and M10 Flanged Nylock Hex Nut (item #36), as
shown in Figure 4-14. You can adjust the Mig Gun
Holder to an angle that best suites your need.
Fully-tighten this nut.
Summary of Contents for B-CART-W
Page 14: ...14 NOTES ...
Page 15: ...15 NOTES ...
