33
33
On-Edge Shaping
If the shaper fence does not firmly support wide stock,
use the existing bolts in the fence to attach a special
rigid high fence.
Note:
Be sure the bolt holes are
countersunk in the special fence.
End Shaping
When end shaping narrow stock, it is important
that at least one half of the workpiece end be in
contact with either the infeed or outfeed fence.
Use a guide similar to the one shown in Figure 15
which tightly clamps the scrap piece to the
workpiece and provides the necessary width.
Straight Line Bevel Edge Shaping
To perform a bevel edge cut, the infeed edge of the jig is
placed against the infeed fence and clamped to the table.
The outfeed fence is moved forward as necessary to
compensate for the cut.
WARNING:
End shaping a narrow workpiece without a special guide
could result in the workpiece rocking into the cutterhead causing minor, or major,
personal injury.
Summary of Contents for SS-2725
