Baileigh Industrial SS-2725, Operator'S Manual

Page: 30 / 56

27
27
OPERATION
CARELESS ACTS . Give the work you are doing your undivided attention. Looking around,
talking to someone, and horseplay are careless acts that can result in serious injury.
This section gives instructions on the basic operations of this shaper. It is in no way
comprehensive of every shaper or application. It is strongly recommended that you read books,
trade magazines, or get formal training to maximize the potential of your shaper and to minimize
the risks of injury, or damage to equipment or work stock.
Initial Operation
1. Connect the machine to the power source.
2. Make sure you have read the safety instructions at the beginning of the manual and that the
machine is setup properly.
3. Make sure all tools and objects used during set up are cleared away from the machine.
4. Press the START button to turn the machine ON.
5. Check to make sure the spindle is rotating in a clockwise direction when the switch is in the
FORWARD position.
Listen to and watch for abnormal noises or actions. The machine should run smoothly with little
or no vibration or rubbing noises. Immediately turn the shaper OFF if you suspect any problems
and fix any problems before starting the shaper again.
WARNING:
For the sake of clarity, the shaper guard has been omitted
from most illustrations. All shaper operations must be done with the proper guard in
place and any other device which ensures the safety of the operator.
CAUTION:
Always wear proper eye protection with side shields, face
shield, safety footwear, and leather gloves to protect from, chips, dust, burrs, and
slivers.
WARNING:
MAKE SURE THAT THE FENCE, ANY ACCESSORIES, JIGS,
SPINDLE, CUTTER, OR ROUTER BIT ADAPTER BEING USED ARE TIGHT AND NO
LOOSE ITEMS ARE ON THE TABLE.