33
33
8. Now that you have a pre-bend on both ends, it is time to roll the final diameter.
9. Back down the rear idler roll and start rolling the piece forward and reverse as shown in view
“D”.
10. Start raising the idler roll gradually and continue rolling the piece forward and reverse until
you have reached the finished diameter.
Note: To achieve a cone configuration, adjust the idler roll on one end only.
11. To remove a finished piece part from the top roll, loosen
both top roll adjustment bolts (
#24
).
12. With the help of an assistant, lift the left end of the top roll,
up and out, keeping the right end gears meshed as much
as possible. The other person will slide the finished cylinder
off. The roll is heavy, so
DO NOT
attempt this alone.
CAUTION:
Have an assistant support the top roll when removing finished
cylinders from the top roll. Failure to adequately support the top roll may result in the
roll falling, and causing personal injury.
24
C
D
Summary of Contents for SBR-5220
