Baileigh Industrial SBR-5220, Operator'S Manual

Page: 35 / 52

32
32
Rolling Operation
1. Back off the idler roll by turning the two adjustment bolts counterclockwise ( ccw ) as in view
“A” below.
2. Unscrew the top roll adjustment bolts until there is enough gap between the top and bottom
rolls to allow the piece part to fit between.
3. Rotate the handlebar
to advance the piece part about 1” (25.4mm) beyond the rolls.
4. Tighten the top roll adjustment bolts to hold the piece part firmly.
5. Raise the idler roll enough to get the material started in an upward direction against the top
front roll as shown in view “B.
6. Rolling the initial edge slightly will give it a pre-bend.
7. Back the piece out, turn the piece part and repeat the sequence for the other end. See view
“C” below.
A B
Idler Roll
Adjustment
Bolt
Handlebar
Rotation
Top Roll
Adjustment
Bolt
consistent gap
piece part