Baileigh Industrial 1013715, Operator'S Manual

Page: 24 / 52

21
21
Loading the Piece Part
1. Use the vise hand-wheel to open the jaws wider than the width of the piece.
2. Measure and mark off the length of material to be cut.
3. Place the piece on the flat surface in between the vise jaws.
4. Slide the piece through the jaws so the scribed length mark lines up with the blade or disk.
5. Push the piece up against the back vise jaw.
6. Turn the hand-wheel clockwise (cw) to clamp the piece.
Setting Cut Length
1. Setting the cut length eliminates measuring
duplicate pieces.
2. Measure and mark the length of material to be cut
off.
3. Load the piece part.
4. Line up the cut.
5. Clamp the piece part.
6. Loosen the hex nut (A) at the base of the stop
riser.
7. Slide the stop riser along the long rod so that the
tip of stop riser (B) touches the end of the piece
part.
8. Tighten the hex nut at the base of the bar riser (A).
Using the Stop Bar
1. Cut off the first length from the clamped piece part.
2. Unclamp the piece part.
3. Slide the piece part forward until it reaches the tip (B) of the stop bar.
4. Clamp the piece part.
5. Proceed with the cutting cycle.
A
B