Baileigh Industrial 1013715, Operator'S Manual

Page: 19 / 52

16
16
ASSEMBLY AND SET UP
Locate and prepare the machine for assembly.
1. Locate and remove the material stop, rubber feet, and feed handle from around the base.
2. Using proper lifting techniques lift the machine off the skid and place on a solid, level bench
capable of supporting the full weight of the machine and the material to be cut.
Install the Rubber Feet.
3. Carefully tip the machine on its side and install the four
rubber feet (I).
4. Remove the oil fill transport plug from gear
transfer case.
5. Remove the packing material (J).
6. Use a wrench to unscrew an M20x40 hex
screw from the oil fill hole (K).
WARNING:
For your own safety, DO NOT connect the machine to the
power source until the machine is completely assembled and you read and
understand the entire instruction manual.
I
J
K