4
2.4
Procedure
To explain the installation, the procedure in Table 4 uses a Baicells Atom OD04L Outdoor Low-Gain CPE as the
example. Refer to the
on the Baicells website to complete some steps as indicated.
Table 4: Installation Procedure
1.
With the CPE powered OFF, loosen the screws on the
waterproof cover and lift to access the interfaces.
2.
Insert the SIM card into the SIM slot.
Attention
: Never power on the CPE while installing or
uninstalling the SIM card. Doing so could damage the
card and the unit.
3.
Using the Ethernet cable, connect the CPE PoE port
and the router WAN port.
Caution
: Do not connect unsupported devices to
the router WAN port, as it may cause damage.
Per the associated steps in the CPE user manual
installation procedure:
4.
Prepare the ground wire and connect one end of it to
the CPE ground terminal and the other end to a
reliable grounding point (earth).
5.
Close the CPE's waterproof cover, and tighten the
screws.
6.
Mount the CPE at its outdoor location, assuring proper
alignment to the nearest eNB tower.
7.
Power the CPE ON, and check the satus of the LEDs to
ensure it is operating as expected.
8.
Connect the router's power adapter to the power
connector on the back of the unit, and the other
end to a power outlet.
9.
Turn power to the router ON.
10.
Check the LED indicators to verify normal
operating status per
in section 2.2 of this
guide.
NOTE: If either the CPE or the router is not running the correct firmware, the router's LTE signal LED
will be OFF. Check for the latest firmware on the Baicells website, or contact
The setup is complete and ready to work. To configure features using the CPE GUI, go to the next section.
