251
Replacement of the wheel with fault
5
E
m
erg
en
cy
tr
ea
tm
en
t
6. Rotate clockwise the jack and lift up the
vehicle with the jack handle and wheel
dismantling wrench until the wheel with fault
leaves the ground.
7. Remove the wheel mounting bolts, remove the
wheel with fault, and place the wheel with fault
in the appropriate position below the vehicle with
the outer surface upward, and replace the spare
wheel.
Caution
●
When the vehicle is traveling, the heat
generated by the brake system can cause
wheel mounting bolts hot, so you should be
careful not to be burned when dismantling
the wheels.
Warning
●
Strictly comply with the notices for
operation of jack.
●
Do not jack up the vehicle at the position
other than a predetermined support point.
●
Do not place a pad above or below the
jack.
●
Do not use any jack not equipped with
the vehicle.
●
Never jack up the vehicle too high.
●
In the course of lifting, please continue
usly observe the conditions of vehicle. If
you find that the vehicle is obviously tilted
or acts abnormally, please stop the lifting
operation, identify and eliminate the
problem, and then carry out the operation
again.
Install the spare wheel.
Warning
●
It is prohibited to use the spare wheel
with damage or reaching wear limit. Try to
avoid using tires more than 6 years.
●
After installing the spare wheel, tire
pressure should be checked and adjusted
to within a predetermined range.
●
Spare wheel is only used in emergency
situations, so you should drive carefully at
speed less 80km/h when spare wheel is
used, and avoid sharp acceleration and
emergency braking.
Summary of Contents for SENOVA X55
Page 6: ......
