C AU T I O N
When using Tansun electrical heaters, basic precautions should always be
followed to reduce the risk of fire, electric shock, and injury to persons, including
the following:
Read all instructions before using this heater.
•
Before using this appliance:
- Check that the voltage indicated on the type plate corresponds to the
mains supply voltage.
- Ensure that the heater has been securely fastened in its final mounting
position.
•
Do not locate the heater immediately below a socket outlet.
•
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
•
Children of less than 3 years should be kept away unless continually
supervised.
•
Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
•
CAUTION - Some parts of the product can become very hot and cause
burns. Particular attention has been given where children and
vulnerable people are present.
•
Remove the plug from the mains socket (or disconnect pole switch) during
installation, cleaning and/or replacing the emitter/lamp and always ensure
that the emitter/lamp is cool.
•
The heater is designed for outdoor use. Only install indoors in conjunction
with a suitable energy saving controller. Please contact Tansun for a
controller for this application.
2
7
. Remove the two screws as highlighted on in Fig. H to take out the side reflector bracket and reflector
assembly that allows access the emitter holding clip. Repeat at opposite end of emitter.
8
. Where the emitter wires are fed through the gasket into the terminal box (Fig. H), gently pull the emitter
wires through the body of the heater so the wires exit the terminal box.
9
. At the opposite end of the emitter, the wire will be clearly visible in the emitter wire tube so gently pull the
wire (Fig. J) out of the tube until it is free.
10
. One at a time pull the spring clips back in the direction shown in Fig. K and lift up the ceramic caps of the
emitter to remove it from the heater.
11
. The emitter should now be removed from the heater. Refit the new emitter in reverse order ensuring the
ceramic caps are correctly seated in the emitter holders, no wires are trapped and all screws are fully
tightened.
7
Fig. J
Fig. K
Fig. H
