4
. Disconnect the emitter from the connector blocks by unscrewing the screws highlighted above in Fig. E.
5
. Unscrew the four screws (see Fig. F) from the end casing and remove from the heater body. Repeat at
opposite end.
6
. Slide out the side covers from both ends and slide out the guard from either end as shown in Fig. G.
R E P L AC I N G T H E E M I T T E R ( L AM P )
If you are in any doubt about following the procedure below, please contact us for technical
assistance. The mains power should be disconnected before any attempts are made to replace the
emitter. The following should be carried out with compliance to the latest electrical regulations.
Please read the notes on the previous page with regards to handling and buying a replacement
emitter before proceeding. We also recommend you read through the procedure and refer to the parts
diagram on the back page of this manual before commencing work.
1
. Ensure the heater and emitter are cool and the power supply is disconnected by removing the plug from
the socket outlet.
2
. Providing there is reasonable access and you are standing on a safe and stable platform, the emitter can
be replaced with the heater still mounted. Otherwise, remove the heater from its mounting and work on a
safe, flat surface.
3
. Remove the screws from the terminal box (Fig. D) and lift off the cover.
6
Fig. G
Fig. F
Fig. E
Fig. D
•
Do not use an extension cord with this product because the extension cord
may overheat and cause a risk of fire.
•
Keep the mains supply cord away from the body of the heater which will get
hot during use.
•
Arrange the mains supply cord so it cannot be tripped over or damaged.
•
Do not cover or obstruct the heater while it is in use.
•
Do not insert any object through any slot or opening in the heater.
•
Do not use if a guard is not present.
•
Do not install less than the minimum mounting distance from the floor.
•
WARNING: This heater is not equipped with a device to control the room
temperature. Do not use this heater in small rooms when they are occupied
by persons not capable of leaving the room on their own, unless constant
supervision is provided.
•
Do not touch the heater when it is turned on, as the body gets hot.
•
Do not use the heater in a bathroom, laundry areas and similar locations.
Never locate the heater where it may fall into a bathtub or other water
container.
•
A heater has hot parts inside. Do not use it in areas where petrol, paint, or
flammable liquids are used or stored.
•
WARNING: This appliance must be connected to a supply that is earthed!
I M P O R TA N T -
S AV E T H E S E I N S T R U C T I O N S F O R F U T U R E R E F E R E N C E
R I SK O F FI R E
Keep combustible materials such as furniture, papers, clothes and curtains at
least 1.8m (6 feet) from the front of the heater and away from the sides and rear.
If the heater is to be used outside, we recommend that a waterproof or indoor
socket outlet is used.
3
