background image

English

2

 FULL-CRANK  HEDGE  TRIMMER 

MODEL: WBP26HT

 

GENERAL POWER TOOL SAFETY WARNINGS

Spark Arrestor Note

nOTE: For users on U.s. Forest land and in the states 

of California, Maine, Oregon and Washington.

 All U.S. 

Forest Land and the state of California (Public Resources 
Codes 4442 and 4443), Oregon and Washington require, by 
law that certain internal combustion engines operated on 
forest brush and/or grass-covered areas be equipped with a 
spark arrestor, maintained in effective working order, or the 
engine be constructed, equipped and maintained for the 
prevention of fire. Check with your state or local authorities 
for regulations pertaining to these requirements. Failure to 
follow these requirements could subject you to liability or 
a fine. 

This unit is factory equipped with a spark arrestor.

 If 

it requires replacement, contact a BADGER Parts & Repair 
Service Center to install the appropriate muffler assembly.

 

CAliFORniA PROPOsiTiOn 65

 

WARNING:

 

Engine exhaust, some of its 

constituents and certain finished components 

contain or emit chemicals known to the State 

of California

 to cause cancer and birth defects 

or other reproductive harm. 

Wash hands after 

handling.

Read All Instructions Before Operating

 

WARNING:

 

Read all safety warnings, 

instructions, illustrations and specifications 

provided with this power tool. 

Failure to follow all 

instructions listed below may result in electric shock, 
fire and/or serious injury. 

sAVE ThEsE insTRUCTiOns

 

a ) 

Read the instructions carefully.

 Be familiar with the 

controls and proper use of the unit. 

b ) 

Do not operate this unit when tired, ill or under 

the influence of alcohol, drugs or medication. 

c ) 

Children must not operate the unit. 

Teens must be 

accompanied and guided by an adult. 

d ) 

All guards and safety attachments must be 

installed properly before operating the unit. 

e ) 

Inspect the unit before use. 

Replace damaged 

parts. Check for fuel leaks. Make sure all fasteners are 
in place and secure. Replace parts that are cracked, 
chipped, or damaged in any way. Do not operate the 
unit with loose or damaged parts. 

f ) 

Be aware of risk of injury to the head, hands and 

arms. 

g ) 

Carefully inspect the area before starting the 

unit. 

Remove and objects that may be thrown or 

become entangled with the unit. 

h ) 

Clear the area of children, bystanders and pets; 

keep them outside a 50-foot (15 m) radius, at a 

minimum.

 Even then, they are still at risk from thrown 

objects. Encourage bystanders to wear eye protection. 
If you are approached, stop the unit immediately. 

i ) 

Squeeze the throttle control and check that it 

returns automatically to the idle position.

 Make 

all adjustments or repairs before using the unit. 

j ) 

This unit is intended for occasional, household 

use only.

Safety Warnings For Gas Units

 

WARNING:

 

Gasoline is highly flamable and its 

vapors can explode if ignited. 

Take the following 

precautions

a ) 

Store fuel only in containers specifically designed 

and approved for the storage of such materials.

b ) 

Always stop the engine and allow it to cool 

before filling the tank.

 Never remove the fuel tank 

cap or add fuel when the engine is hot. Always loosen 
the fuel tank cap slowly to relieve any pressure in the 
tank before fueling.

c ) 

Always add fuel in a clean, well-ventilated 

outdoor area where there are no sparks or 

flames. 

DO NOT smoke.

d ) 

Never operate the unit without the fuel cap 

securely in place.

e ) 

Avoid creating a source of ignition for spilled 

fuel. 

Wipe up any spilled fuel from the unit 

immediately, before starting the unit.

f ) 

Move the unit at least 30 ft. (9.1 m) from the 

fueling source and site before starting the 

engine.

 DO NOT smoke.

g ) 

Never start or run the unit inside a closed room 

or building.

h ) 

Breathing exhaust fumes can kill. 

Operate this unit 

only in a well ventilated outdoor area.

Operating Warnings

 

WARNING:

 

Wear safety glasses or goggles that 

meet current ANSI / ISEA Z87.1 standards and are 

marked as such.

 Wear ear/hearing protection when 

operating this unit. Wear a face mask or dust mask if 
the operation is dusty.

a ) 

Wear heavy long pants, boots, gloves and a long 

sleeve shirt.

 Do not wear loose clothing, jewelry, 

Summary of Contents for WBP26HT






















Reviews: