PAGE 29
ADJUST DECK BELT TENSION
The deck spring tension is critical. if the tension is too
high, premature failure of the deck belt and blade
spindles can occur. If the tension is too low, the belt can
"jump off" or slip on the pulleys. This results in reduced
cut quality and early belt failure.
Spring tension adjustments can be made by sliding the
bolt shown above forward or backward in the slot of the
deck. Belt tension should be 60-65 lbs. with the deck at
its lowest setting.
Use a belt tension gauge to ensure the proper tension.
Your dealer or service center will have a belt tension
gauge or you can buy one (Part Number 041-9999-00).
BLADE SHARPENING
The blade on the top (see photo) was utilized long after
replacement was required. In addition to a decline in cut
quality, failure to replace a worn or damaged blade
creates a major safety hazard. Bad Boy recommends that
blade sharpening be performed by a professional.
Deck Belt Tension Adjustment
Belt Tension Gauge
