36
To change the final gear oil
1.
Place the ATV on a level surface and raise up with a lift or jack.
2.
Place an oil pan under the final gear case to collect the used oil.
3.
Remove the final gear oil filler bolt; the final gear oil drain bolt and their gaskets to drain
the oil form the final gear case.
NOTE:
Dispose of lubricant in accordance with local regulations.
4.
Install the drain bolt and its new gasket and then tighten the bolt to the specified torque.
Tighten torque: 32.36 Nm or 24 ft. lb (330kgf/cm)
5.
Refill with the recommended final gear oil to the brim of the filler hole as shown.
Oil quantity: SAE#90, .37 quarts (0.35 L)
6.
Check the oil filler bolt gasket for damage and replace it if necessary.
7.
Install the oil filler bolt and its gasket and then tighten the bolt to the specified torque.
Tighten torque: 32.36 Nm or 24 ft. lb (330kgf/cm)
8.
Check the final gear case for oil leakage. If oil is leaking, check for the cause.
16. SEAT
To remove the seat
1.
Open the lock by turning the key.
2.
Pull up on the seat at the rear.
To install the seat
Insert the tongue on the front of the seat into seat
holders and push down on the seat at the rear. Make
sure that the seat is securely fitted.
17. STORAGE COMPARTMENTS
This ATV equipped with two storage compartments located at the front right and left side. To access
the storage compartment, insert the key in the lock and turn to unlock, remove the storage
compartment cover.
Drain
bolt