![background image](http://html1.mh-extra.com/html/backyardcity-pool/bermuda/bermuda_assembly-and-installation_3347765031.webp)
STEP 21 – STRAIGHT SIDE T
OP PLATE INSTALLATION:
Straight side
top plate
#10 screw
Straight side
upright
Straight side top
plate drops
inside straight
side upright
& is attached
on sides with
4-#10 screws
Fig. 61
STEP 22 – SECURING THE CURVED SIDE UPRIGHTS:
*
Top Plate
Top Rail
Upright
Pool Wall
Lift back of top plate
up slightly to snap
over the stabilizer rail
Put front screw of
top plate in loosely
*
Sample Top Plate - Yours may look a little different
Fig. 62
Now is the time to install the straight side top plates. Simply place each one over a different oval upright and the
stabilizer rail, match the holes on the top plate to those on the straight side upright, and fasten them together using
four #10 x ½" screws in each.
For the uprights on the curved ends of the pool, you can now pull the front of the top plate (the hooked part) over the
stabilizer bar and, after you are positive that the upright is level, you can now add the final two screws necessary to
secure the uprights to the pool. If the uprights are not level, it will be very difficult to get the top rails to fit together.
It is a good idea to use a carpenter's level to check that the upright is standing perfectly straight. If the upright is
leaning left or right this is easy to correct before putting the final two screws into the top plate.
Summary of Contents for Bermuda
Page 36: ......