![background image](http://html1.mh-extra.com/html/backyardcity-pool/bermuda/bermuda_assembly-and-installation_3347765027.webp)
STEP 17 – PREPARING THE COVE:
Using neutral alkalinity sifted earth or fine sand without pebbles, build a 2" base over the entire pool area to
protect the liner. Make sure that the straps and the pressure plates are covered entirely. If the base does not fully
cover the metal components, they will show through and will damage the liner. If using vermiculite or foam base,
you must have at least two inches of soil or sand on top of the straps and pressure plates. Vermiculite alone will
not properly cover these metal components, possibly allowing damage to the liner. Do not use any substance with
high alkaline or acid content, such as peat moss. It will cause the pool to corrode.
Next, using sifted earth or fine sand, build a 6" to 8" pool cove inside
the metal wall along the entire circumference. The cove will prevent the
liner from creeping under the wall and will also protect the liner from
any metal corners of the pool framework. THIS STEP IS NOT
OPTIONAL – IT MUST BE DONE! Since earth containing chemicals
can cause discoloration or corrosion, it is suggested that you place
polyethylene plastic sheeting under the cove around the perimeter of the
wall, so no earth comes in contact with the metal. Since the presence of
such chemicals is beyond the control of the manufacturer, such damage
is not covered by the warranty. The plastic sheeting will not prevent a
washout in the event that your liner is damaged. The plastic is only to
protect the metal framework of the pool from corrosion.
After the cove and base are in place, rake and tamp the entire pool area.
Make sure that no sand remains on the wall above the cove. This could
cause pinholes in your liner.
8”
8”
2”
Fig. 54
STEP 18- HANGING LINER:
Pool
Water
Top Wall Rim
(supplied with pool)
Beaded
Liner
Pool Wall
Coping Bead
Receiver
SNAP BEAD LINER
SNAP BEAD LINER
The beaded liner track should be installed onto the pool wall all
of the way around the pool. These pieces should be as close
together as possible. Leaving spaces between bead tracks can
cause liner problems down the road.
Once all of the beaded liner track is on the wall, you can snap
the liner bead into the beaded liner track at four random points
around the pool. After that is done, and you are satisfied with
how the liner is situated within the pool, you can continue
snapping the remainder of the liner into place around the pool.
Go around the entire pool again making certain that the liner is
securely snapped into the track. This is important to confirm
so that the liner does not pull out while under the pressure of
being filled with water.
Fig. 55
Summary of Contents for Bermuda
Page 36: ......