PAGE 48
Step 26
Items Needed
1- 10' Speedy Slide
6- Y41 Ground Stakes
Hardware Needed
6- ¼” x 1” Phillips Truss Head Bolts
6- ¼” Phillips Barrel Nuts
12- Fender Washers
6- 5/16” Lock Washers
Drill three holes at one end of the
Plastic Slide Bed
using a 3/8” drill bit and using the dimensions shown in Fig. 1.
(This
end will be the top of the Slide.)
Take note of the Slide Bed surface finish, the dull side will be towards the ground. Place or (clamp)
W100935
Slide Support Bottom
centered on the bottom
( dull side )
of Slide Bed and ½” from the edge. Transfer holes
on the board through to Slide Bed as shown in illustration.
Attach the W100935 Slide Support Bottom to the bottom of the Slide Bed using ½” bolts, Lock Washers and
Barrel Nuts as shown below.
Drill holes with
a 3/8” drill bit.
Drill holes with
a 3/8” drill bit.
