Instruction 24-9428
5
Fyrite Tech
3.0 SETTING UP THE ANALYZER
3.1 Scope
Before usng the analyzer . . .
• Check batteres (Secton 3.2)
• Connect probe to analyzer (Secton 3.3)
• Check setup (Secton 3.5)
3.2 Checking & Replacing the Batteries
Install fresh batteries as described below. Check the analyzer for sufficient
charge pror to each use. Replace the batteres f the low-battery symbol
appears n the lower rght corner of the screen. To replace the bat-
teres:
1. Remove battery cover from back of analyzer.
2. Remove old batteres and dspose of them properly.
3. Observng the polarty markngs nsde the battery compartment,
nstall four ‘AA’ Alkalne batteres as shown n Fgure 3-1.
4. Replace battery cover.
Figure 3-1. Battery Installation
Remove battery cover by
pushing down on cover
and sliding it outward
