Copyright © 2008 - 2009, Baby Trend Inc., All Rights Reserved.
Copyright © 2008 - 2009, Baby Trend Inc., All Rights Reserved.
7
8
SAFETY
SAFETY
Before placing your children in the stroller,
please follow the instructions below.
WARNING:
Always set
brakes when the stroller is not being
pushed so that the stroller will not
roll away. NEVER leave stroller
unattended on a hill or incline as
the stroller may slide down the hill.
BRAKES
To engage brakes, apply light downward pressure
to the brake lever located on each rear wheel. The
stroller may require slight forward or rearward
movement in order to line up the teeth on the
brake with each wheel brake cluster. (Fig. 15a)
Check that the stroller will not move and that both
brakes are properly applied. To release, gently lift
up on the brake lever. (Fig. 15b)
TO SECURE THE CHILD
WARNING:
Avoid serious
injury from falling or sliding out.
Always use the safety harness.
STRANGULATION
HAZARD:
Child can
strangle in loose straps. Never leave
child in seat when straps are loose
or undone.
TANDEM STOLLER - 5-Point Harness
• The shoulder straps of the 5-point harness
has 2 attachment positions. Select the loop
position that places the shoulder strap level
with, or below the top of the child’s shoulder
and feed the shoulder harness under the
correct loop. To adjust harness slot unhook
the shoulder strap from the crotch buckle.
(Fig. 16) Feed the shoulder strap through the
harness spread slots. You can access these
slots from the rear of the seat. Feed shoulder
strap through approiate slot and reattach
shoulder strap to crotch buckle.
• Carefully place the child in the stroller seat
and bring the safety harness around the
child’s waist and over the shoulders. Place
the crotch strap and between the child’s
legs. Insert the male end of each shoulder /
waist belt into the buckle on the crotch strap.
Tighten the harness to be snug around the
child’s waist and over the child’s shoulders.
(Fig.17)
• To release, apply pressure to both sides of
each male clip until the clip is released.
(Fig. 18) This process requires a moderate
amount of effort so as to prevent an
accidental release by your child.
NOTE:
Buckles may be hard to release when
1st used.
TRAVEL SYSTEM - Safety Belt
• Strap the safety belt over the infant car seat
through the seat belt slots on the infant car
seat, connect the buckles together (Fig. 19).
The safety belts for the infant car seat is
located in small pockets on outer sides of seat
pads. Tighten the strap so the infant car seat
fits snug and can't move.
IT IS VERY IMPORTANT THAT THE
INFANT CAR SEAT STRAP IS ALWAYS
TIGHTLY FASTENED AROUND THE
INFANT CAR SEAT.
NOTE:
When the stand feature safety belt
is not used, you must store the stand feature
safety belt back to its storage.
JUMP SEAT - 3-Point Harness
• Secure the child with the jump seat 3-point
harness (Fig. 20) when child is sitting on the
jump seat.
Fig. 15a
Fig. 15b
Fig. 16
Fig. 17
Shoulder Strap
Squeeze
Adjust for a snug fit
Crotch Strap
Waist Strap
Fig. 18
Fig. 19
Fig. 20
