Copyright © 2008 - 2009, Baby Trend Inc., All Rights Reserved.
Copyright © 2008 - 2009, Baby Trend Inc., All Rights Reserved.
ASSEMBLY
ASSEMBLY
5
6
To rotate the child tray:
In order to attach an infant car seat to the stroller,
the child tray must be rotated to the vertical
position. Press red buttons on both sides of the
child tray to rotate down 90 degrees. (Fig. 9)
To remove the child tray:
Pull both release levers located on the underside
of each side of the tray and lift upward. (Fig. 10)
CUP HOLDER
(sold separately)
This is an optional accessory item that can be
purchased online at www.babytrend.com. The
removeable child tray can be replaced with 2
individual cup holders. It is ideal for an older
child.
To attach the cup holder:
Push the cup holder downward and onto each side
of the front armrests until it snaps into place.
(Fig. 11)
CANOPY
To attach the front canopy:
Line up the male fittings on the canopy with
the slots on the armrest and push both fittings
downward until snapped into place. (Fig.12) To
open the canopy, push forward on the front edge
of the canopy while holding the rear of canopy in
place. To fold the canopy, pull backward on the
front edge.
To remove the front canopy:
Press the snap botton under the armrest and pull
to release the fitting from the slot. Repeat for the
other side.
To attach the rear canopy:
Line up the male fittings of the lower connection
with the female fittings on the handle frame and
push inward.( Fig. 13b) Lock upper connection of
canopy into locking slots. (Fig. 13a) Fasten velcro
to the stroller frame.
To remove the rear canopy:
Unfasten the velcro from stroller frame. Press the
upper snap bottons (Fig. 13c) located on the outter
side of parent tray to release the upper connection,
then press both snap bottons on the inner side of
the lower connection and pull outward.
Note: The canopys are only needed when using
the seated positions for your children. They are
not needed when using with the infant car seats.
PARENT TRAY
To attach the parent tray, position the tray so that
the hinges for the storage compartment are facing
foward. Snap the parent tray to the stand at the
top of the frame. Check that the tray is securely
latched in place. (Fig. 14)
Fig. 12
Fig. 9
red button
slot
Fig. 13a
upper connection
Fig. 14
Fig. 13b
lower connection
Fig. 13c
upper connection
snap button
release lever
Underside of the child tray
Fig. 10
Fig. 11
