![background image](http://html1.mh-extra.com/html/baby-lock/pro-stitcher-blps3/pro-stitcher-blps3_instruction-and-reference-manual_3401441101.webp)
9.2 | Troubleshooting
Pro-Stitcher User Manual
Problem/Symptom
Corrective Measure
The Pro-Stitcher stitches, but the stitch lengths
vary and the quilting machine slows down or
even stops in some directions.
The problem can be narrowed to a specific encoder
wheel by running the quilting machine manually. Start
the quilting machine from the handlebars in Stitch
Regulated mode and only move the machine left
and right. Then try only moving front and back. If the
quilting machine stops stitching while moving front and
back, then the problem is with the encoder mounted
to the back of the machine. If it stops stitching left
and right then the problem is with the encoder on the
carriage. Make sure the encoder wheels roll on the
tracks when moving the quilting machine and also that
the gray stitch regulator cable is plugged in securely to
the encoders.
The white gears do not engage the blue flexirack
When the quilting machine is pushed by hand,
the horizontal and/or vertical crosshair lines do
not move.
Make sure the white gears fully engage the blue rack.
Use the manual engagement/disengagement tool
to adjust. Insert into the hole at the front of the EZ
Carriage.
The X and/or Y axis gears are only partially engaged
Stitched designs appear jagged or wobbly.
With the Pro-Stitcher powered and motors
engaged and enabled (locked in position),
pressing the machine side to side or front to
back allows a little motion but the white gear
does not rotate.
Make sure the white gears completely engage the blue
rack. If the X-axis gear does not naturally fully engage
without lowering the white gears, it may be because
the X-axis motor assembly is slightly narrower than the
carriage. It may be necessary to insert a thin washer
between the X-axis assembly bracket and the side(s) of
the carriage. To do this, remove the black screws that
mount the motor assembly to the sides of the carriage
and wedge the washers between the inner wall of the
carriage and the motor assembly bracket. This should
relieve the pressure/bend added to the motor assembly
if it is slightly undersized for the carriage.
One or more of the pulleys/gears on the X or Y axis assemblies are loose
Stitched designs appear jagged or wobbly.
With the Pro-Stitcher powered and motors
engaged and enabled (locked in position),
pressing the machine side to side or front to
back allows a little motion and the white gear
does rotate.
Monitor the motor assembly while engaged and
enabled to determine which gear/pulley is slipping. It
will most likely be either the gear mounted directly to
the motor shaft or the gear mounted to the shaft that
drives the white gear. Use the appropriate Allen wrench
to tighten both set screws on the gear. The motor gear
requires a 1/16” Allen wrench and the larger gear on
the drive axle with the white gear requires a 5/64” Allen
wrench.