![background image](http://html.mh-extra.com/html/baby-lock/pearl-blqf/pearl-blqf_assembly-instructions-manual_462472022.webp)
22
Fig. 9-1
Fig. 9-2
Fig. 8-1
Fig. 9-4
Fig. 9-3
Step 11: Pole End Assembly
Parts needed
4-Pole Assembly
5-Pole End
2-Short-Bolt Ratchet Wheel Assembly
1-Long-Bolt Ratchet Wheel Assembly
1-Hand Wheel Assembly
1-Hand Wheel Insert
Tools Required
17/13mm Wrench (Provided)
11-1:
Check one pole end to ensure that it
matches
Fig 11-1 and 11-3
.
11-2:
Loosen the nut on the pole end until it
reaches the end of the bolt (
Fig. 11-2
).
11-3:
Holding onto the outside pole end, push
the nut end of the bolt towards the opposite
end of the assembly (
Fig. 11-1
), until the pole
end short-bolt wedge slides out (
Fig. 11-2
).
This makes the outside diameter of the pole
end smaller and ready to be inserted into the
end of the pole assembly.
11-4:
Repeat Steps 11-1 to 11-3 to prepare the
remaining four (4) pole ends for insertion.
NOTE:
A regular M10 nut is provided as an
assembly aid tool if you have trouble holding
the pole end while tightening the pole end into
the pole.
11-5:
Slide one pole end into the end of one
pole assembly as shown in
Fig. 11-4
. Check
that the pole end is inserted completely into the
pole assembly.
11-6:
Completely tighten the nut, using the
17/13mm wrench, while holding the pole end
assembly tightly into the open end of the pole.
This will expand the outer pole end, ensuring a
tight fit into the pole.
Fig. 11-1
Step 11
Pole End Assembly
Fig. 11-2
Push
Fig. 9-1
Fig. 9-2
Fig. 8-1
Fig. 9-4
Fig. 9-3
Fig. 11-3
Inside Pole End Short Bolt Wedge
Outside Pole End
Large Washer
V Bearing
Small Washer
Lock Nut
Pole End assembly comes pre-assembled. Exploded diagram is
for reference only.
Fig. 11-4
Fig. 9-1
Fig. 9-2
Fig. 8-1
Fig. 9-4
Fig. 9-3
Fig. 9-1
Fig. 9-2
Fig. 8-1
Fig. 9-4
Fig. 9-3
Pole End
Wedge
Luke, use existing Fig. 11-5 to create a new graphic with TWO short bolt ratchet sheel
assembly poles, one batting storage pole. delete the label “Make 2 of each”. Label
the two identical poles with these labels “Quilt-Top Pole” “Backing Pole” and label the
bottom pole “Batting Storage Pole”
Loosen Nut