23
11-7:
Repeat
steps 11-5
and
11-6
to add a
second pole end to the other open end of the
pole assembly just built and one pole end to
each of the remaining 3 pole assemblies
(
Fig. 11-5
). Set the pole with two pole ends
aside as the
batting storage pole.
Short-Bolt Ratchet-Wheel Assembly
11-8:
Check the short-bolt ratchet wheel
assembly to ensure that it matches
Fig. 11-6
.
11-9:
Loosen the nut at the end of the short-
bolt ratchet wheel assembly until it nearly
reaches the end of the bolt.
11-10:
Holding onto the outside of the pole
end, push the nut end of the bolt towards the
opposite end of the assembly until the inside
pole end short-bolt wedge slides out (in similar
fashion to
Step 11-3
). This makes the outside
diameter of the outside pole end smaller and
ready to be inserted into the end of the pole
assembly.
Long-Bolt Ratchet-Wheel Assembly
11-12:
Add the hand wheel assembly and
hand wheel insert as shown in
Fig. 11-7
,
aligning the three tabs on the hand wheel insert
with the three notches on the outside pole end.
If the three tabs are not properly aligned, the
hand wheel will spin freely, independent of the
pole.
Outside Pole End
Inside Pole End Short Bolt Wedge
Short Bolt Wedge
Ratchet Wheel
Large Washer
V Bearing
Small Washer
Hex Nut
Fig. 11-6
Short-bolt ratchet assembly comes
pre-assembled. Exploded diagram is
for reference only.
Fig. 11-7
Step 11
Pole End Assembly (continued)
Luke, use existing Fig. 11-5 to create a new graphic with TWO short bolt ratchet sheel
assembly poles, one batting storage pole. delete the label “Make 2 of each”. Label
the two identical poles with these labels “Quilt-Top Pole” “Backing Pole” and label the
bottom pole “Batting Storage Pole”
Long Bolt Ratchet
Wheel and Hand
Wheel Assembly
Ratchet Wheel
Hand Wheel
Small Washer
Lock Nut
Large Washer
V Bearing
Outside Pole End
Hand Wheel
Insert
Tab
Hole
Long bolt ratchet wheel assembly comes pre-assembled
without hand wheel and hand wheel insert. Exploded
diagram is included for reference.
Fig. 10-1
Fig. 9-6
Fig. 2-1
Fig. 1-1
Batting Storage Pole
Fig. 11-5
Fig. 10-1
Fig. 9-6
Fig. 2-1
Fig. 1-1