7
Step 2: Table Assembly
Parts needed
2-Table Section
2-Table Splice
12- M8x16mm Socketed Button Head Cap
Screw QF09318-07
Tools Required
5mm Allen Wrench (provided)
2-1:
With the table sections face down (large
round screw holes for track supports up), slide
the two table sections together end to end, as
close as possible. Place a table splice onto the
sections as shown in
Fig. 2-1
, lining up the
holes in the splice with those in the sections.
Repeat with remaining table splice on the
opposite side of the table sections.
2-2:
Place four (4) M8x16mm QF09318-07
through the side of each table splice and finger-
tighten them into the table sections. (
Fig. 2-1
)
2-3:
Finger-tighten two (2) M8x16mm
QF09318-07 through the top of each table
splice.
2-4:
Pull the two (2) table sections as close
together as possible to remove gap.
2-5:
Using the 5mm Allen wrench, tighten the
four side screws on each table splice, until the
splice touches the side of the table section,
and then loosen the screws ½ turn.
2-6:
Using the 5mm Allen wrench, tighten fully
the two (2) top screws on each table splice.
Finally, fully tighten the four (4) side screws on
each table splice. (
Fig. 2-2
)
Step 2
Table Assembly
Fig. 2-1
Fig. 2-2