![background image](http://html.mh-extra.com/html/baby-lock/pearl-blqf/pearl-blqf_assembly-instructions-manual_462472016.webp)
16
Fig. 7-3
Plastic Track
Track Support
Insert the other end of the coupler into second
prepared track support section. Hold the two
adjoining track support sections tightly together
and thread an M5x8mm QF09318-304 into
the first hole of the second track support and
lightly tighten. You may need to gently rock
the track support to seat the coupler. Insert the
second screw into the track supports, align and
tighten. Once aligned, fully tighten all M5x8mm
QF09318-304.
7-5:
Insert a plastic track completely into one
side of the aluminum track supports
(Fig. 7-3)
.
The plastic track should slide into the track
support easily. If a plastic track binds slightly,
try backing it out a little, then try pushing it
further. If the plastic binds badly, check the
track supports for debris, burrs, misalignment
or damage. In same manner, insert plastic track
in other side of track support.
7-6:
Repeat Steps 7-2 through 7-5 to make the
second track.
7-7:
Attach Tracks
. Secure one assembled
track to the back of the quilting frame. Line up
the track support by holding it tightly against
the plastic table top as you secure it to the
frame, using six (6) M6x12mm QF09318-303
as shown in
Fig. 7-5
and
Detail 7-5
on next
page. Do not tighten screws at this time. They
need to be loose to accommodate adjustments
in the next step. In same manner, attach the
remaining track support to the front of the
frame using six (6) M6x12mm QF09318-303.
NOTE:
The extrusions have a wider shoulder
on one edge of the track. This shoulder is to be
placed toward the inside of the table over the
edge of the black plastic tabletop. (Fig. 7-4)
7-8:
Align Tracks
. Place the carriage on the
tracks at one end of the table. Roll back and
forth along the length of the table, establishing
the distance between the tracks, taking care to
check that the wheels are engaging the track
on both the front and the back of the carriage.
Move both tracks in tandem to the back of the
table as far as possible. (Slots in the table allow
this movement – if you have not tightened the
screws too tight.) Double-check that the back
track is straight along the back edge of the
table. Fully tighten the screws in the back track
only for now.
Step 7
Track Assembly (continued)
Fig. 7-4
Wider
shoulders
to inside